ANSI Rotating Welded Metal Bellows Single Cartridge Seal

Product Line Features

• Simple cartridge seal installation.
• Sleeve is isolated from process fluid.
• 3/8″ NPT flush connection allows for cooling and venting of seal.
• 1/4″ NPT vent and drain connections provide differential sizing to minimize the potential of improper piping.
• Non-sparking throttle bushing is positively retained to avoid pressure blow out, minimizing leakage in the event of seal failure.
• Vantage seal glands include flush, vent, and drain connections and a close-clearance, non-sparking throttle bushing to direct any leakage to the drain connection.
• Flush, vent, and drain connections available to be piped at multiple locations.
• Angled gland connections allow for easier pipe fitting.
• Setting clips provide positive axial and radial settingof the Vantage cartridge seal to ensure proper seal installation. The Vantage setting clips are easy to access for simple removal.
• Convertible gland design to accept over four (4) design configurations.

VRB3/VBRB3 Features

• Rotating design uses centrifugal force for self-cleaning
• Uniform 360° transfer of torque to the rotating face
• Welded metal bellows replace the dynamic elastomer which can hang up the seal faces
• No springs to clog or break
• No fretting
• Only three (3) static elastomers – eliminate seal failures caused by dynamic O-ring “hang up” and offers cost savings when upgrading to Perfluorelastomers.

Materials of Construction

Operating Parameters

Note: Maximum temperature/speed/pressure/runout indicates operating extremes independently and does not imply the seal will function at these extremes at the same time.

Registered Trademarks:
Viton® – Dupont Performance Elastomers; Aflas® – Asahi Glass Co.;
Teflon® – E.I.Dupont de Nemours and Co; Hastelloy® – Haynes International, Inc.

For more information on the ANSI VRB3/VBRB3